Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision |
meshtastic:station [2023/02/19 20:29] – [Meshtastic Mesh Device Station Edition] neilhao | meshtastic:station [2024/03/17 00:46] (current) – [Meshtastic Mesh Device Station Edition] neilhao |
---|
Starts from 2022/May/31 to ~~LASTMOD~~ (Last Modification) | Starts from 2022/May/31 to ~~LASTMOD~~ (Last Modification) |
| |
^:!: Order Yours Today^^^ | **The Station G1 has been discontinued and has been replaced by the [[https://wiki.uniteng.com/en/meshtastic/station-g2|Station G2]]. Meshtastic Mesh Device Station G2 is an upgraded design of Station G1, using the latest ESP32 S3 MCU. As an RF research project, Station G2 also brings key updates in RF. The primary RF design goal of Station G2 is to improve the Lora receiving sensitivity by about 4dB based on a dedicated Ultra-Low Noise Figure LNA. Also increase the transmit power and improve Signal to Noise ratio of short data packets by designing the Fast-Transient DC-DC for 35dBm Lora PA.** |
|Official Store| [[https://shop.uniteng.com/product/meshtastic-mesh-device-station-edition/|https://shop.uniteng.com]]|**In Stock**| | |
|Tindie | [[https://www.tindie.com/products/neilhao/meshtastic-mesh-device-station-edition/|https://www.tindie.com]] | **In Stock**| | :?: [[https://wiki.uniteng.com/en/meshtastic#station-edition|Edition Comparisons between our Meshtastic Products]] |
:?: [[https://wiki.uniteng.com/en/meshtastic|Edition Comparisons between our Meshtastic Products]] | |
===== Overview ===== | ===== Overview ===== |
{{ :meshtastic:meshtastic_mesh_device_station_edition_overview.jpg?nolink&400|}} | {{ :meshtastic:meshtastic_mesh_device_station_edition_overview.jpg?nolink&400|}} |
| |
====Accessories - 12V Battery Docker==== | ====Accessories - 12V Battery Docker==== |
| |
| **Because Station Edition G1 could be powered by either USB Type C (PD Protocol with minimum 9V2A is required) or 2Pins Socket (Pitch=2.5mm, 8VDC-20VDC, 2A minimum). Power supply choice is very convenient, so that Battery Docker has been discontinued.** |
| |
|Schematics for 12V Battery Docker|{{{ :meshtastic:meshtastic_mesh_device_station_edition_12v_battery_docker_28_jul_2022.pdf |}}|Version: 28 Jul 2022| | |Schematics for 12V Battery Docker|{{{ :meshtastic:meshtastic_mesh_device_station_edition_12v_battery_docker_28_jul_2022.pdf |}}|Version: 28 Jul 2022| |