This is an old revision of the document!
Starts from 2021/Sep/08 to 2021/09/07 23:24 (Last Modification)
This is an upgraded version of my pervious project ESP32 Flash Download Tool. Power monitor feature has been introduced to this Flash Download Tool by adding TI INA226 power monitor, an OLED screen and ESP32-WROOM-32E (4MB Flash). The theoretical minimum current resolution is 100 uA which should be sufficient for low power application development.
|2||PTC Resettable Fuse (I hold = 1A, I trap = 1.8A, Time to trip = 300ms)|
|3||USB Type C Socket|
|4||Silicon Labs CP2102N USB to UART Bridge|
|5||EN Button (S2)|
|6||IO0/BOOT Button (S1)|
|7||Header 2.54mm 2*3P|
|8||Header 2.54mm 1*6P|
|9||Header 2.54mm 1*6P|
|10||Header 2.54mm 1*6P|
|11||Header 2mm 1*6P|
|12||Header 1.5mm 1*6P|
|13||Current-sensing resistor for TI INA226|
|15||Flash Download Socket for onboard ESP32-WROOM-32E|
|16||User Button A, Adjusting local sampling rate by 100ms interval (Interval Range: 0ms to 1000ms).|
|17||User Button B, Adjusting local sampling rate by 50ms interval (Interval Range: 0ms to 1000ms).|
|18||User Button C, Clear the local sampling rate. The interval will be 0ms (fastest) after pressing button C.|
|19||User Button D, Display SSID and Password for AP mode, current IP address and WIFI mode (AP or Client).|
|20||OLED Screen, 1.3 inch, 128*64 resolution|
|21||LED Indicators for CP2102N's TXD and RXD|
|22||ESP32-WROOM-32E (4MB Flash)|
|23||Power Switch for Target System|
If the SSID and password not configured or the Flash Download Tool not in the AP’s coverage range, the Flash Download Tool will enter the AP mode. Current WIFI mode will be indicated on the OLED screen. “C” for Client Mode, “A” for AP Mode.
The SSID and Password for AP mode will be shown if User Button D is pressed.